USER’S MANUAL

HexiSplit



for Video

55 Cabot Court, Hauppauge, NY 11788

Tel: (631) 273-0404 Fax: (631) 273-1638

www.commspecial.com

Communications Specialties Pte Ltd

Singapore

Tel: +65 6391 8790 Fax: +65 6396 0138

Introduction

Introduction

Thank you for purchasing this fine distribution amplifier (splitter) for

composite video. This product allows you to distribute a single video

signal to up to 6 monitors simultaneously. You may also distribute the

signal to any composite-video based equipment. Each connection can

be located up to 250 feet away from the splitter.

This product is supplied with the following components:

1 HexiSplit for Video

1 Power Supply (a power cord may also be included on 220 Vac

models)

1 User’s Manual and Product Registration card

Key features of these splitters are:

* 300 MHz bandwidth

* Independently buffered outputs

1 Full bandwidth on both Y and C channels

HexiSplit is a registered trademarks of Communications Specialties, Inc.

P/N 101193 Rev. D



Installation

Installation

1. Connect a video cable from the video output of the computer or

video equipment to the connector on the rear of the splitter

marked

VIDEO IN.

2. Connect one or more video monitors or video equipment to any or

all of the

MONITOR

outputs.

3. Extension cables may be used to support monitor lengths to 250

feet. Communications Specialties sells these extension cables in

various lengths. Contact your dealer for details.

4. Plug the power supply supplied into the jack on the rear of the

splitter marked

POWER.

5. Plug the power supply into a 110Vac or 220Vac wall outlet as

appropriate. The front panel LED should glow red indicating the

unit is properly powered.

6. The monitor(s) or video equipment will now display the input

signal.



FCC User Information

WARNING:

This equipment generates, uses, and can radiate radio

frequency energy and if not installed and used in accordance with

the instruction manual, may cause interference to radio

communications. It has been tested and found to comply with the

limits for a Class A computing device pursuant to Subpart B of Part

15 of FCC Rules, which are designed to provide reasonable

protection against such interference when operated in a commercial

environment. Operation of this equipment in a residential area is

likely to cause interference in which case the user at his own expense

will be required to take whatever measures may be required to correct

the intereference.



Limited Warranty

Communications Specialties, Inc. (CSI) warrants that for a period

of three (3) years after purchase by the Buyer,

HexiSplit

for Video

will be free from defects in material and workmanship under normal

use and service. A Return Material Authorization (RMA) number

must be obtained from CSI before any equipment is returned by the

Buyer. All material must be shipped to CSI, Hauppauge, New York

at the expense and risk of the Buyer. Units returned to the Buyer will

be shipped freight collect.

CSI’s obligation under this warranty will be limited, at its option,

to either repair or replacement of defective units, including free

materials and labor, at its customer service facility in Hauppauge,

New York. In no event shall CSI be responsible for any incidental or

consequential damages or loss of profits or goodwill.

CSI shall not be obligated to replace or repair equipment that has

been damaged by fire, war, acts of God, or similar causes, or

equipment that has been serviced, altered, or improperly installed,

or abused.

RMA numbers and repairs can be obtained from:

Communications Specialties Headquarters

Tel: (631) 273-0404

Fax: (631) 273-1638

CSPL, Singapore

Tel: +65 6391 8790

Fax: +65 6396 0138